I initially used FlorisBoard, but I changed to OpenBoard for the automatic corrections. As far as I know, FlorisBoard can only underline errors in red, then you have to tap the word and select which option it should be. On OpenBoard, a correction is made automatically, and it’s quite accurate!
Just installed last week, and the dictionary integration with two different languages works fine for me. Autocorrect is not yet supported, if I remember correctly.
I think the problem is that the temperature of the heat source is too low. It’s quite hard to recuperate energy from low temperature waste heat economically. With waste heat from high temperature sources, you can use steam, which can ‘store’ a lot of energy because of the latent enthalpy difference, which results in low mass flow rates. With water, you would need higher mass flow rates, so bigger tubes, pumps …
*Rely 🤣. It’s true, but for me it’s just much faster to have auto-correction, I usually know how words should be written, but I hit the wrong letter quite often, so that’s why this works for me.