I’ve read manual for my new 3D printer but it was in a foreign language so I had to cook up a way to understand it, luckily I travel a lot so learning languages is not that difficult for me. I hope that this writing paints good enough of a picture on how it went. I forged up some way to accelerate my learning process so that I could get trough it swift like an arrow. There certainly were some steep inclines which I had to overcome but in the end it all went swimmingly. The only issue was that I could not muster any courage to approach my crush. I just stood there like a stump and stared at her eyes that glistened like stars. In the end it turned out she was a hoe so I dodged a bullet.
I prefer the ergonomics of original SC over SD but SD has better controls. I want the best of both.