hello,
I don’t know if this is the right place to ask this question but could someone explain me how a UEFI system boots, I couldn’t find a guide online. I want to know because I don’t understand certain GRUB commands and how it get installed.
I just copy paste commands from Arch wiki and it just magically works without me knowing anything about it.
all the different distros use different grub command parameter and it’s so confusing. eg, Arch and Gentoo.
Arch command: grub-install --target=x86_64-efi --efi-directory=esp --bootloader-id=GRUB Gentoo command: grub-install --efi-directory=/efi
why both command is different? exactly where does grub gets installed?
sorry if this is a naive question but i really don’t understnad GRUB.
Since you use UEFI, you don’t have to use GRUB. It basically consists 90% of cruft left over that was needed for BIOS boot, and has a lot of moving parts and bad design (such as a single config file which has to be shared between OSes, which is so complex it needs a generator for it).
Try systemd-boot, it’s lightweight and well designed.
Anyway, looks like the target parameter is default now, the “esp” in the arch command is supposed to be substituted for the ESP path, for example /efi, so the only difference is bootloader-id. Which looks like that’s the label that show up in your UEFI setup for the boot entry.
Yeah I know everyone likes to hate on systemd, but I like systemd-boot way more than GRUB. It just does its job and stays out of the way, I never have to fart about with it at all.